Snap. Clamp. Ride.
Quick Clamp lets any motorized scooter bar click onto a wheelchair in seconds. Fully 3D‑printable for about $25 in parts.
Start Building Watch 3 min Pitch
3 minute overview of the project and its impact.
Fast
Clip on or off in under a few seconds.
Printable
Standard 0.4 mm nozzle · 50 percent infill · PLA or PET‑G.
Affordable
About $25 total for filament and hardware (covers two clamps).
Universal
Fits frame diameters from 12.7 mm to 33 mm.
Four Steps to Your Clamp
1
What’s Needed
Gather filament, silicone pads, screws, and a 3D printer.
2
Take Measurements
Measure wheelchair and scooter diameters.
3
Generate Models
Custom STLs generated instantly in your browser.
4
Print & Assemble
Print, pad, screw, and roll out.